Operation Manual

Operation
Operating Instructions 610-01/630-01 - 02.0 - 08/2015 39
6. Thread the tape through the guide (7).
Fig. 17: Threading the tape
7. Thread the tape through the guide (10).
8. Adjust guide (10) approximately to the width of the tape used.
9. Guide the tape through the pneumatic clamp (11).
10. Switch on the sewing machine.
11. Activate threading mode.
For this purpose, press both keys on the key panel (9) at
the same time. The clamp is released and compressed air
is provided to feed the tape in
to the guide piece (12).
12. Introduce tape into the guide piece (12) and let it run through
until there is no excess t
ape any longer between the pneumatic
clamp (11) and the guide piece (12). Grip the tape with, e.g.,
tweezers.
13. End threading mode by pressing on one of the two keys on
(9) – Key panel
(10) – Guide
(11) – Pneumatic clamp
(12) – Guide piece
⑨
⑩
⑪
⑫