Operation Manual

Performance description
Operating Instructions 610-01/630-01 - 02.0 - 08/201510
2.4 Control panel OP7000
The following settings are performed using the OP7000 control
panel:
• Parameter settings for sewing seams.
• Programming, saving and managing seam programs.
• Switching from manual sewing to automatic sewing.
2.5 Tape unwinder (610 only)
• With the tape unwinder, the Dürkopp Adler 610 can be used to
tape armholes, necklines etc.
• The tape feed guides the tape automatically during sewing. The
t
ape unwinder makes it possible to sew the tape without ten-
sion.
• After a pre-programmed seam length, the tape cutter cuts the
t
ape in the seam. The tape does not therefore project beyond
the fabric edges.
• Replaceable pressure feet make it possible to work with
3 different tape widths.
Number of stitches on delivery [rpm] 3200 (recommended
number of stitches)
Needle stroke [mm] 32
Sewing foot stroke during lifting [mm] 9
Operating pressure [bar] 6
Air consumption [NL per working cycle] 0.1
Length, width, height (packaging) [mm] 1350 / 900 /
1250
1350 / 900 /
11
00
Weight of the upper section [kg] 60 54
Total weight (upper section, accessory pack,
mot
or controller, packaging) [kg]
114 108
Rated voltage [V/Hz] 230 V, 50/60 Hz
Rated power [kVA]
0.5
Technical data 610-01 630-01