Operation Manual

Settings via software
Operating Instructions 610-01/630-01 - 02.0 - 08/2015104
7.7.5 Correcting length (LENGTH CORRECTION)
All segments are graded with the same factor. In some segments
it is important for the quality of the result that the grading be
increased or decreased. In order to eliminate these localized
deviations, you can use the length correction function.
Prerequisite:
• The operating mode EDIT is displayed.
1. Press the P
LEN
button.
 The length correction user interface is displayed.
Fig. 56: Length correction interface
2. Sew the segment.
3. Switch to the next segment by hand on the control panel
or using the knee switch.
 Sewing progress is displayed graphically.