Operation Manual

Table of Contents
Operating Instructions 581 - 00.0 - 02/20152
5.12 Sewing............................................................................ 54
5.12.1 Sewing using the push buttons....................................... 54
5.12.2 Sewing with the foot pedal.............................................. 56
5.13 Customer service............................................................ 58
6 Maintenance.................................................................. 59
6.1 Inspection ....................................................................... 60
6.2 Cleaning ......................................................................... 62
6.3 Lubricating ...................................................................... 63
6.4 Changing the cutting blocks and blade........................... 65
6.4.1 Sub-class without multiflex ............................................. 65
6.4.2 Sub-class with multiflex .................................................. 67
7 Setup.............................................................................. 71
7.1 Checking the scope of delivery....................................... 71
7.2 Removing the transport locks ......................................... 71
7.3 Installing the frame ......................................................... 73
7.4 Fitting the table plate ...................................................... 73
7.5 Using the ring bolt........................................................... 74
7.6 Securing the reel stand................................................... 74
7.7 Securing the frame ......................................................... 75
7.8 Setting the working height .............................................. 76
7.9 Fitting the controller ........................................................ 77
7.10 Electrical connection....................................................... 80
7.11 Equipotential bonding ..................................................... 80
7.12 Installing the suction container ....................................... 80
7.13 Connecting the pneumatic system ................................. 82
7.14 Setting the operating pressure ....................................... 83
7.15 Lubrication ...................................................................... 84
7.16 Topping up the oil ........................................................... 87
7.17 Adjusting the material edge stops .................................. 88
7.18 Carrying out a test run .................................................... 89
8 Software settings.......................................................... 91
8.1 User level........................................................................ 91
8.1.1 Basic operation............................................................... 91
8.1.2 Single buttonhole mode.................................................. 91
8.1.3 Sequential mode............................................................. 92