Operation Manual

3.2 Removing and inserting the clamping plates

Caution: Danger of injury !

The removing and inserting of the clamping plates 1 has to be done

with the sewing automat switched off or in the position “Threading

mode” (see chapter “Threading mode”).

Remove the clamping plates

–

Slightly lift the right clamping plate 1 at the back and pull it

backwards.

Then remove the clamping plate sideways to the right.

–

Slightly lift the left clamping plate 1 at the back and pull it

backwards.

Then remove the clamping plate sideways to the left.

Insert the clamping plates

–

Push the clamping plate to the front into the rec ess.

–

Snap in the clamping plate in the pin 3.

Hint!

Wrongly inserted clamping plates can lead to damage or injuries.

21 3