Operating instructions

4. Lifting eye bolt

The lifting eye bolt helps you to lift the automat into the stand. For

example you can hoist the automat by a ceiling c rane or you put a rigid

bar (e.g. the bar of the thread stand) through the lifting eye bolt and lift

the automat with 2 persons. The lifting eye bolt is included in the

accessories.

–

Screw the lifting eye bolt 8 on the automat.

–

Lift the automat into the stand.

–

Unscrew the lifting eye bolt 8 when the automat is mounted.

5. Assembly of the main switch

–

Loosen the screw 4 and remove the switching knob 5.

–

Removethemainswitchcover.

For this purpose, unlock the tab in the hole 6.

–

Insert the cable from the control box in the main switch.

–

Connect the cable cores of the control box to the terminals

L1 (1à brown) and L2 (2 à blue).

Connect the protective earth (3 à yellow-green) of the control box

to the main switc h too.

–

Make sure that the notch 7 of the main switch faces down.

–

Put the main switch cover again. Put on the switching k nob 5 and

screw it tight.

Hint

If you manufacture the table top yourself, fit the main switch at

an easily accessible place because the main switch is also the

emergency stop switch.