Operation Manual

Settings via software (sewing automat)
Instruction manual 550-532 - 00.0 - 07/201566
7.21.3 Setting parameter U085
Parameter U085 must be set after new software has been loaded.
Prerequisite:
• Machine is in programming mode, Ready key LED is off.
1. Press and hold the Memory key for 6 s.
 The key LED illuminates.
2. Use the +/- Program keys to set parameter number U085.
3. Press the Ready key.
4. Use the +/- Function keys to enter a function value of 1.
5. Press the Ready key.
6. Press the Memory key.
 The key LED goes out.
7.21.4 Checking the software version
1. Press and hold the Memory key for 6 s.
 The controller beeps twice, the key LED lights up.
2. Press the +/- Program keys and select parameter U097.
3. Press the Ready key.
 The current software versions are displayed:
• M X.XX = Main program
• P X.XX = Control panel
• T X.XX = Servo motors
• A X.XX = Seam patterns
4. Press the +/- Function keys and check the respective
software version.
5. Press the Ready key.
6. Press the Memory key.
 The key LED goes out.