Operation Manual

Settings via software (sewing automat)
Instruction manual 550-532 - 00.0 - 07/2015 61
E 3 0 5 Thread cutter
position error
Thread cutter knife not in the
home position
•Main switch OFF.
• Check the sensor.
E 3 0 6 Thread-pulling
knife position
error
Thread-pulling knife not in
the home position
•Main switch OFF.
• Check the sensor.
E 3 3 2 Clamping foot
position error
Clamping foot not in the
home position
•Main switch OFF.
• Check the sensor.
E 5 0 1 Data read error Data not present or stored in
the wrong format
• Store the data anew on
the USB key.
E 5 0 2 USB read error MOT file faulty • Store the data anew on
the USB key.
E 5 0 3 SUM read error CHECKSUM data in MOT
file faulty
• Store the CHECKSUM
file anew on the USB
key.
E 5 0 4 Endblock error No Endblock in the MOT file • Store the Endblock file
anew on the USB key.
E 5 0 5 USB read error USB key not found • Main switch OFF.
•Main switch ON.
• Plug in the USB key
again.
E 5 0 6 USB read error Reading from U01 ~ U10 not
possible.
•Main switch OFF.
•Main switch ON.
• Plug in the USB key
again.
E 5 0 7 Own seam
pattern read
error
Read error U01 ~ U10 • Download data again.
E 5 0 8 Own seam
patterns file
error
Read error U01 ~ U10 • Check the file type.
E 5 0 9 Own seam
patterns file
error
Read error U01 ~ U10 • Check the file type.
E 5 1 0 Own seam
patterns file
error
Read error U01 ~ U10 • Check the file type.
• Store the data anew on
the USB key.
Error message Description Possible cause Remedy