Operation Manual

Settings via software (sewing automat)
Instruction manual 550-532 - 00.0 - 07/201560
6. Use the +/- Program keys to select the next stitch.
7. Repeat steps 3 to 5 for all further stitches.
8. Press the Ready key to save the edited seam pattern.
9. Press the Reset key.
 The key LED goes out.
10. Press the USB key.
 The key LED goes out.
7.20Error messages
If an error occurs, the Error symbol LED illuminates.
Error message Description Possible cause Remedy
E8Error
Table data
Table data could not be read • Save the table data
anew.
E10Error
Seam pattern
number
The selected seam pattern is
not stored in ROM or has
been disabled. Seam pattern
"0"
• Press the Reset key to
confirm the seam pat-
tern number.
E30Error
Upper needle
bar position
Needle bar is not in the
upper position
• Check the connections.
• Rotate the needle bar to
the top dead center.
E40Error
Needle field
area
Needle field area exceeded • Press the Reset key.
• Check the X/Y scaling.
E42Error
Enlargement
Sewing length is more than
10 mm
• Press the Reset key.
• Check the seam pattern
and the X/Y scaling.
E45Error
Seam pattern
data
Seam pattern data could not
be accepted
• Press the Reset key.
• Check the ROM.
E 5 0 Pause Reset key pressed while
sewing.
Sewing automat stopped.
• Press the Reset key.
• Trigger the thread cutter.
• Start the sewing process
anew.
E302Error
Machine head
Machine head is tilted over. • Tilt the machine head
back into place.