Operation Manual

Settings via software (sewing automat)
Instruction manual 550-532 - 00.0 - 07/201554
 The seam pattern is sewn. At the end of sewing, the Program
display shows the next seam pattern sequence, e. g. <1.2>,
the Function display shows the next seam pattern number etc.
4. To switch between seam patterns in a sequence, press the
+/- Program keys and select the desired seam pattern.
7.15Deleting a seam pattern sequence
Prerequisite:
• Machine is in programming mode, Ready key LED is off.
1. Press the Memory key and key P3 at the same time.
2. Press the +/- Program keys to select a seam pattern
sequence (C01 ~ C25).
3. Press the Ready key to confirm the seam pattern sequence.
4. Press the Reset key to delete the seam pattern sequence.
5. Press the Ready key to confirm the deletion.
6. Press the Memory key to exit the memory mode.
7.16Finishing sewing
1. Press the Ready key.
 The key LED illuminates. The controller is in the sewing
mode.
2. Main switch OFF.
Notice
If the sewing automat is switched off without pressing the Ready
key then any changed values are not saved.
CAUTION
Risk of injury from the point of the needle and
moving parts
Do not reach under the raised clamp.