Operation Manual

Operation of the button feeder
Instruction manual 550-532 - 00.0 - 07/201538
Fig. 16: Sorting by peg II
4. Loosen the setscrew (6).
5. Adjust the height of the peg (5).
6. Re-tighten the setscrew (6).
Sorting by plate
The plate (8) is set such that only buttons with the bevel on the
bottom edge facing down are transported further.
Fig. 17: Sorting by plate I
1. Loosen the screw (7).
2. Shift the position of the plate (8) in the elongated hole such
that the tip (9) of the plate separates the buttons that are posi-
tioned incorrectly.
(5) - Peg (6) - Setscrew
⑥
⑤
(7) - Screw (8) - Plate
⑧
⑦