Operation Manual

5.2.1.2 Program Selection via Menu

If the program number is unknown, all programs can be run through

sequentially in the following manner.

Order of operations

–

Press the “P” key.

Change-over to the “Program Selection” mode.

–

Press the “Y” key.

The first program is shown.

Each pressing of the “Y” key moves to and shows the next

program.

If the program has valid data assigned to it, the following display

appears:

If the program has no valid data assigned to it, the following

appears:

–

If the displayed program is to be selected,

press the “E” key. (Example: Program 01)

The following display appears.

5.2.1.3 Side Selection in a Program

After selection of a program one always goes first to the right piece (if

a right sleeve has been programmed).

In the automatic mode one can, however, alternate between “right” and

“left” sleeves at any time.

–

Press the “E” key.

The controls switch to the left sleeve.

The display shows:

–

Press the “E” key again.

The controls switch to the right sleeve again.

The display shows: