Operation Manual

5.1.4 Bartack Inversion

The bartack set in the parameters (see Part 4: Programming

Instructions) is inverted (suppressed) by simultaneously pressing the

“F” and “2” keys.

Seam beginning:

–

Press the “F” and “2” keys simultaneously.

The bartack is not sewn.

Seam end:

–

Press the “F” and “2” keys simultaneously.

The bartack is not sewn.

5.2 Sewing with a Program (Automatic)

In automatic operation the step and program number

displays show the selected program and the active step.

Additionally, the selected piece (left or right sleeve) is shown in the

program number display. At the end of the program this display blinks.

5.2.1 Program Selection

5.2.1.1 Direct Program Selection

Programs already generated for a specific sleeve can be called up as

follows:

–

Press the “P” key.

The display shows:

–

Enter the two-digit program number.

Example: Program 17 is to be called up enter => “17".

The display shows :

–

After activation of a program, step 01 is displayed.

The program is immmediately ready for operation.

The “Automatic” operation mode is active.

–

If the program is not present in the memory, the left display blinks.

By holding down the “Y” key and tapping the “P” key, a new

program can now be entered or the program search repeated by

pressing the “P” key.