Operation Manual

3.6 Deleting a Program
- Hold the
"Y"
key down and hold down the
"P"
and
"E"
keys approx.
2 seconds until the blinking stops.
The program is deleted.
3.7 Generating a Program
–
Press the
"P"
key.
–
Enter a three-digit model number which has not been used yet.
The left display blinks showing "---".
–
Hold the
"Y"
key down and tap the
"P"
key.
The dots in the middle display blink.
–
Enter the new crimping value.
–
Press the hand switch.
The entry value is stored in memory.
The next value can be entered.
Setting and deleting the end of a part
–
Mark the end of a part with the
"E"
key.
A small "e" appears to the right in front of the part number in the
display.
–
An end mark can be deleted again by pressing the
"E"
key again.
Exiting the programming mode
–
Hold the
"Y"
key down and tap the
"P"
key.
A capital "E" appears in front of the part number in the right display
as a program end marker.
The blinking dots disappear.
2 seconds after the pressing of the keys the first step of the model
appears in the display.
16