Operating instructions

Number Error position Description Cause Error elimination
4304 Memo-Dongle Wrong type Boot-Dongle is inserted
Use Memo-Dongle
4307 Memo-Dongle Wrong class Dongle of the wrong
class was inserted
Insert correct Dongle
Format the Dongle
5101 Contour data-
administration
EEPROM not
initialized
- Control
- Control contains no
machine program
- Check control
- Install machine program
5104 Contour data-
administration
Checksum error - Control
The machine resets itself
automatically.
Inform DA-Service
5301 Contour data-
administration
Data memory full Too many stitches in
contour
Reduce number of
stitches
Inform DA-Service
5303 Contour data-
administration
Data memory-
overflow
Too many stitches in
contour
Reduce number of
stitches
Inform DA-Service
5305 Contour data-
administration
Invalid data storage
attempt
Too many stitches in
contour
Reduce number of
stitches
Inform DA-Service
5306 Contour data-
administration
Invalid data r equest
Carry out buttonhole
contour reset
Inform DA-Service
5315 Contour data-
administration
General error
Carry out buttonhole
contour reset
Inform DA-Service
6151-6952 I²C/ CPU/ Mem-
Manager
Fault Switch machine off and
then on again
Inform DA-Service
7251-7659 ASC/ SSC/
RS485
Fault Switch machine off and
then on again
Inform DA-Service
8151-8351 IDMA/ Xilink/
Test pins
Fault
(8151-8159: only an
entry in the event
memory – no further
impairment)
Switch machine off and
then on again
Inform DA-Service
43
1