Operating instructions

5.4 Adjusting the cut length
Correcting the buttonhole length (Cut length). The adjustment is
possible in both, the main menu and programming mode.
–
Select the line “cut length” in the main menu with the arrow keys ñ
and ò
–
Press the OK-key.
The curser blinks under a digit value.
–
Change between the digits with the arrow keys ï and ð.
–
Increase or decrease the value of the selected digit with the arrow
keys ñ and ò.
–
Press the OK-key to confirm the value.
5.5 Selecting a starting variant
Select a starting variant
The starting variant of the starting s titch serves to ensure the correct
sewing start for different materials and threads. The starting variant is
individually set for each individual buttonhole.
Starting variant A (Standard)
–
The starting stitches are flat form stitches.
Starting variant B (Thin material, lining)
–
The starting stitches are flat form stitches. With the use of a cross
stitch the upper thread holds better to the material.
Starting variant C (very thin material)
–
The starting stitches are flat form stitches.
With the use of forward and backward bartack stitches the upper
thread holds better to the material.
Starting variant D (very thin material)
–
Alternative to starting variant C.
Select starting variant:
–
Press P-key.
–
Select the line “Starting variant” with the arrow keys ñ and ò.
–
Press the OK-key.
–
Select the relevant Starting variant A, B, C or D with the arrow
keys ñ and ò
–
Press the OK-key
–
Press the ESC-key.
30