Operating instructions

5.6 Mounting the control unit

–

Mount the control unit (DAC III) onto the table plate using 4 wood

screws according to figure 2 on page 10. The side with the bushes

for the motors (three bushes, one under the other) has to point to

the right side.

5.7 Mounting the waste container

–

Remove cover 1 of the waste container.

–

Take the filter fleece 2 out of cover 1.

–

Screw cover 1 onto the table plate with two w ood screws.

–

Refit the filter fleece 2 into the cover 1.

–

Refit the fleece clamping plate.

–

Finally stick the container 4 onto the cover 1.

5.8 Mounting the maintenance unit and the set value initiator

–

Screw plate 5 onto the set value initiator 6.

–

Screw the set value initiator plate 6 to the maintenance unit

L-bracket 7 on the cross strut of the frame 8 according to figure 4.

5.9 Mounting the pedal and the traction rod

–

Screw pedal 9 onto the frame strut 10.

For ergonomic reasons the pedal center should be directly under

the needle.

–

Fasten the traction rod 11 to the set value initiator 12 and the

pedal 9.

–

Loosen screw 13 on the traction rod 11.

–

Set the length of the traction rod 11 so that pedal 9, without any

pressure on it, has an inclination of about 10°.

–

Tighten screw 13 again.

12 13 11