Operating instructions

1.1 Altering parameter values

1.1.1 Numerical values

Numerical values can be altered as follow s:

–

Selectthelinewiththevaluetobealteredwiththecursorkeysñ

and ò.

–

Actuate the OK key.

The cursor flashes under a digit of the numerical value.

–

Change between the digits with the cursor keys ï and ð.

–

Increase or reduce the value of the selected digit with the cursor

keys ñ and ò.

In case of parameters which cannot optionally be altered another

possible parameter value is indicated by actuating the cursor keys

ñ and ò.

–

Actuate the OK key.

The set value is taken over.

–

If the set value is not to be taken over, actuate the ESC key.

The initially set value is restored

1.1.2 Selection of a parameter

Some parameters allow to choose between several possibilities.

The pa rameter can be altered as follow s:

–

Selectthelinewiththevaluetobealteredwiththecursorkeysñ

and ò.

–

Actuate the OK key.

–

Change between the possibilities with the cursor keys ñ and ò.

The selected parameter is displayed.

–

Actuate the OK key. The set parameter or value is taken o ver.

–

If the set parameter or value is not to be taken o ver, actuate the

ESC key.

The initially set parameter or value is restored.