Operating instructions

6.6 Needle protection

Standard:

In the furthest right needle entry point the needle protection in looping

stroke position should abut on the needle w ithout pushing it aside.

Setting :

–

Bring the machine in looping stroke position.

–

The bolt of the needle bar linkage must be at the left flank of the

adjusting sheet (furthest right entry point).

–

Attach the needle protection 1 in such a w ay that the needle is

slightly pushed out of the way. Align the needle p rotection with a

butt-end, soft tool according to the instructions.

6.7 Alignment of the bobbin case holder

Standard :

The holder should be at the same level as the bottom part of the

bobbin case (Line C-D).

The back surfaces of the holder and the bottom part of the bobbin case

should be at the same level (A-B).

Setting :

–

Align the height of the holder 2 with an appropriate bending tool

according to the instructions.

–

Shift the holder after loosening the screw 3 according to the

instructions.

ATTENTION!

The holder has to be adjusted in such a way that the left lug of the

bobbin case holder does not touch the back of the hook.