Operation Manual

10.2 Oil lubrication
Caution, danger of injury!
Oil can cause skin rashes.
Avoid excessive contact with the s kin.
Wash thoroughly after contact.
CAUTION!
Handling and disposing of mineral oils is subject to statutory
regulations.
Take used oil to an authorised receiving center.
Protect the environment.
Ensure that you do not spill any oil.
Only use lubrication oil DA 10 or a similar oil with the following
specifications to lubricate the locking unit:
–
Viscosity at 40°C: 10 mm²/s
–
Flash point: 150°C
DA 10 can be obtained from DÜRKOPP ADLER AG sales centers
under the following part numbers:
20 ml container: 9047 000011
1 litre container: 9047 000012
2 litre container: 9047 000013
5 litre container: 9047 000014
Maintenance work Explanation Operating
to be carried out hours
Lubricating the button
sewing attachment
The button sewer is fitted with a central oil
wick lubrication system. The bearing points
are supplied from oil reservoirs 2 and 3.
- The oil level must not go below the red
line on the two oil reservoirs
.
- Top up with oil through hole 1 up to the red
line.
8
91
1
321