Operation Manual

Content
Using this menu item the content of a memory dongle inserted into the
control unit can be displayed.
Before loading the following four data areas a window appears for
each of them to confirm the selection.
–
Press
ï (No) to cancel the procedure or
ð (Yes) to perform the procedure.
The time required to load the data depends on the number of s ewing
pattern programs and free seam contours.
Free seam contours
This menu item starts loading all free seam contours.
All free seam contours on the machine are deleted when loading the
dongle.
Sewing patter n programs and sequences
This menu item starts loading all sewing pattern programs and
sequences.
All sewing machine programs and sequences on the machine are
overwritten when loading the memory dongle.
If sewing machine programs or sequences relate to free seam
contours that are not available these are deleted again after loading.
In this case the free seam contours should be loaded first or the whole
machine.
Machine parameters
This menu item starts loading the machine parameters.
The following data is loaded from the memory dongle:
Cutting speed, number of referencing procedures, feed position,
maximum sewing speed, stop position, the current sewing patter n
number and standard sewing patter n data if the equipment matches.
The machine parameters on the machine are overwritten when loading
the memory dongle.
Whole machine
This menu item starts loading all the aforementioned data areas.
The data on the machine is deleted when loading the memory dongle.
76