Operation Manual

Type of operation Operation Description
Traveling operation
(Op 1)
Intermediate cutting
Intermediate cutting can be programmed
in a contour up to 10 times.
There must be at least 3 stitches
between 2 intermediate cutting
procedures.
Thread tension operation
(Op 2)
Thread tension 1
Thread tension 2
Thread tension 3
Thread tension 4
Thread tension 5
Thread tension area 1
Thread tension area 2
Thread tension area 3
Thread tension area 4
Thread tension area 5
Speed operation
(Op 3)
Speed 200
Speed 400
Speed 600
Speed 800
Speed 1000
Speed 1200
Speed 1400
Speed 1600
Speed 1800
Speed 2000
Speed 2200
Speed 2400
Speed 2600
Default speed
Speed reduction to 200 1/min
Speed reduction to 400 1/min
Speed reduction to 600 1/min
Speed reduction to 800 1/min
Speed reduction to 1000 1/min
Speed reduction to 1200 1/min
Speed reduction to 1400 1/min
Speed reduction to 1600 1/min
Speed reduction to 1800 1/min
Speed reduction to 2000 1/min
Speed reduction to 2200 1/min
Speed reduction to 2400 1/min
Speed reduction to 2600 1/min
Set to default speed
If “No operation” is selected the corresponding stitch operation is
switched off.
70