Operation Manual

–

Select the required stitch by pressing “?”or“?”.

–

Select the stitch by pressing OK.

The sub menu to change a stitch co-ordinate appears.

If a stitch operation is allocated to a stitch this will be marked by an

asterisk (*) instead of a forward slash (/).

Changing the stitch co-ordinates sub menu

This sub menu appears when selecting a stitch co-ordinate from the “Stitch co-ordinates” menu after

inserting or changing a stitch.

Example:

Op 1

Changing the traveling operation of stitch 10.

Enter: see Table on page 70

Op 2

Changing the thread tensioning operation of stitch 10.

Enter: see Table on page 70

Op 3

Changing the speed operation of stitch 10.

Enter: see Table on page 70

Note:

The stitch operation entered is performed after the stitch.

X10: 1.70

Y10: 1.70

Op1: Keine Op.

Op2: Keine Op.

Op3: Keine Op.