Operation Manual

Change contour
Stitch co-ordinates
Selecting the sub menu to change the stitch co-ordinates.
Removing a stitch:
Delete stitch.
Enter: stitch number to be deleted
Inserting a stitch:
Insert stitch.
Enter: Stitch number before which a stitch is to be inserted.
The sub menu to change the stitch co-ordinates appears.
Adding a stitch (at the end)
The sub menu to change the stitch co-ordinates appears.
Parameters
Selecting the sub menu to change the contour parameters
Stitch co-ordinates sub menu
The sub menu appears immediately if the contour to be changed has
99 stitches or fewer.
The following menu appears if the contour to be changed has more
than 99 stitches:
–
Select the required stitch area by pressing “?”or“?”.
–
Select the stitch area by pressing OK.
The “Stitch co-ordinates” sub menu appears.
68
Stichkoord. 0
St.entf.: 0
St.einf.: 0
Stich anfügen
Parameter
Anz.St.: 100
Anz.v.St.:2900
1- 99
100 - 110