Operation Manual

Creating the contour
The X and Y co-ordinates for each individual stitch are entered in this
menu.
Note:
To enter s titch operations (e.g. interim cutting) first of all complete the
contour (enter co-ordinates) and then insert into the Change contour
menu by editing the stitch operation.
X1
Entering the X co-ordinates for stitch 1
Enter: -20.0 … +20.0
Y1
Entering the Y co-ordinates for stitch 1
Enter: -10.0 ...+10.0
Note:
The value X1 can be changed as s hown in Section 8.3.1.
After confirming the value of X1 by pressing OK select menu item Y1
by pressing “ò”.
The values for Y1, X2, Y2, X3 and Y3 can be changed as described for
value X1.
After confirming the entry of Y3 by pressing OK select “Add stitch”
by pressing ò.
After selecting this line by pressing OK the next co-ordinates Xn1 +1
and Yn+1 are specified in the top two menu lines (here: X4 and Y4).
The selection bar switches automatically to the line Xn+1 (here: X4).
The values Xn+1 and Yn+1 can be changed if necessary as described
above. This procedure can be repeated until all the stitch co-ordinates
have been entered.
Adding a stitch
Function to add a stitch.
The co-ordinates for the first three stitches (here: X1/Y1, X2/Y2 and
X3/Y3) are moved upwards and Xn+1/Yn+1 (here: X4/Y4) appears on
the display.
66
X1: 0.0
Y1: 0.0
X2: 0.0
Y2: 0.0
X3: 0.0
Y3: 0.0
Stich anfügen
Parameter