Operation Manual

PWM output test
The function of the magnets is checked with this test function.
–
Start the test function by pressing OK.
–
Select the required output component by pressing “?”or“?”.
–
Switch the selected output component on or off by pressing OK.
–
The current that is flowing through the clamping foot magnet is
displayed.
–
To exit the test function press ESC.
Caution, danger of injury!
Do not put your hands into the running machine during the function
check of the output components.
Output component Function
Y31 Clamping foot magnet
Cf. also paragraph 8.7 Distributor circuit board
55
1
Ausgang Y31: 0
PWM-Ausgangstest