Operation Manual

Output test

The function of the output components is checked with this test

function.

–

Start the test function by pressing OK.

–

Select the required output component by pressing “?”or“?”.

–

Switch the selected output component on or off by pressing OK.

–

To exit the test function press ESC.

Caution, danger of injury!

Do not put your hands into the running machine during the function

check of the output components.

Output Function

component

Y1 Thread wiper magnet

Y4 Thread tension magnet

Y21 Laser marking light 1, if option is activated

Y22 Laser marking light 2, if option is activated

Y23 Laser marking light 3, if option is activated

Cf. also paragraph 8.7 Distributor circuit board

Ausgang Y1: -

Ausgangstest