Operation Manual

Machine parameters
–
Select the required parameters by pressing “?”or“?”.
The symbol for the selected parameters is shown inversely.
–
Start the selected parameters by pressing OK or switch to the sub
menu.
Cut off speed
Enter the sewing motor speed in the last three stitches.
Enter: 200 … 300 [rpm]
Maximum sewing speed
Enter the maximum sewing speed that can be set
Enter: 200 … 2700 [rpm]
Stop position
The positioning of the sewing motor or needle bar can be changed
using the stop position.
Enter: 0 = Thread lever is at the upper dead center
(needle bar is lower)
-15 = Thread lever is 15° off the upper dead center
(Needle bar is higher)
Feed position
Selecting the feed position for the material.
Enter: A = Seam starting point
B = Machine zero point
Note
The following advantages or disadvantages arise depending on the
feed position:
Feed point A = low cycle time
Feed point B = easier feed for larger
sewing patter ns, longer c ycle time.
41
1
Absch.dz.: 210
Max.Dz.: 2500
Stoppos.: -15
Einlegepos.: A
Referenz.: 1
Kl.Fuß-Lüft: A
W.Rückdr.: 0
W.Fsp öf.: 320