Operation Manual

8.6.4.2 Sequence programming mode

This menu item combines the individual sewing patter ns for the

sewing patter n sequences that can be called up.

There is a total of 25 independent sewing patter n sequences

available. Each sewing patter n sequence can be made up of 20

sewing patter ns in any order.

The sewing pattern sequence mode can also be switched on in this

menu.

–

Switch the main switch on.

The control unit is initialized.

The main menu appears.

–

When the main menu appears press S.

The display switches to the sequence programming mode.

–

Select the required menu item by pressing “ñ”or“ò”.

The menu line shown inversely.

–

“Press ESC or ï.

This switches back to the main menu.

Sequence number/ sewing patter n sequence mode

Selecting the sequence to be created or changed.

When creating a new program an asterisk (*) will be displayed before

the number.

Enter: 0 … 25

–

Select the required sequence number by pressing “ñ”or“ò”.

Should sewing pattern sequence mode be switched off select

sequence number 0.

The sequence number is shown inversely.

–

“Press OK.

The program is selected.

Sewing patter n number (1 .. 20)

This menu item is used to select the sewing patter n number t hat is to

be included in the current sequence.

Enter: 1 … 51 (52 - 99 if available)

: Aus