Operation Manual

8.6.2 Programming mode
The parameters for programming sewing patter ns are arranged under
this menu item.
The shape, length, width and speed etc. of the sewing patter n are
entered using the parameters.
–
Switch the main switch on.
The control unit is initialized.
The main menu appears.
–
When the main menu appears press P.
The display switches to the programming mode display.
–
Select the required parameters by pressing “ñ”or“ò”.
The symbol for the selected parameters is shown inversely.
–
Change the selected parameters as described in Section 8.3.
Sewing patter n number
The sewing pattern number that is to be created or changed is
selected using this parameter.
When creating a new program an asterisk (*) is displayed before the
number.
Enter: 51 … 90
–
Select the required sewing patter n program by pressing “ñ”or
“ò”.
–
“Press OK.
The program is selected.
Basic sewing pattern
A default sewing patter n can be selected with this parameter. The
new sewing pattern is to be created based on this.
Enter: 1 … 50 or
91 … 99 if available.
Sewing speed
The required sewing speed is set with this parameter.
Enter: 0...2700 rpm
29
1
:51
:1
: 2000
:35
: 3.4/ 3.4
: 0.0/ 0.0
: 0/ 0.5
: 0/ 0.5