Operation Manual

8.4 Sewing pattern

There are three different sewing patter n types available for the button

sewer 531.

Fixed standard sewing pattern (type 1) (See section 11)

The length, width and sewing speed parameters can be changed

in sewing mode. The laser marking lights can be switched on and

off. The changes are saved.

After selecting another sewing pattern the c hanges are lost,

however.

Sewing patter n numbers 1 - 50 are available for this sewing

pattern that cannot be deleted or overwritten.

Programmable sewing patter n (type 2)

Fixed standard sewing patterns can be changed at programming

level (length, width, sewing speed, laser light 1 - 8) and saved

under a new program number.

Sewing patter n numbers 51 - 90 are available for this sewing

pattern that can be changed or overwritten.

Free seam contours (type 3)

Sewing patter n numbers 91 - 99 are available for these seam

contours. How to create free seam contours is described in

Section 8.6.5.4.

The length, width and sewing speed parameters can be changed

in sewing mode. The laser marking lights can be switched on and

off. The changes are saved.

When another sewing patter n is selected the changes are lost,

however.

25 sewing pattern sequence programs each with up to 20 sewing

patterns for each sewing patter n sequence program can be

created and saved.

8.5. Energy saving mode

The energy saving mode is selected after a time that can be set (1 - 60

minutes) or switched off completely (0 minutes) by using t5 in the

Machine configuration/timesmenu.

When this is selected the clamping foot is lowered to save energy and

thus reduce the amount of heat developed too.

The set time expires if no user entries are made via the control panel,

pedal or manual switch.

Before selecting the energy saving mode the message flashes twice

as an indication that the clamping foot will be lowered immediately.

Then the message stays on the screen.

Normal mode is enabled again. The clamping foot is raised and the

message deleted if the user makes an entry using the control panel,

pedal or manual switch.

The machine is now ready for operation immediately.

Energiespar-Modus