Service manual

Settings via software
48 Service manual 512/532 Version 00.0 - 12/2013
Editing a sewing pattern / contour test: Value 4
Figure 30: Editing a sewing pattern
1. Press the +/- Function buttons to set value 4.
2. Press the Selection button.
 The Program display shows a 1 for the first stitch; the Function
display shows the value for the X-axis; the X-axis LED illuminates.
3. Press the +/- Function buttons to set the coordinates of the 1st stitch
for the X-axis.
4. Press the Selection button.
 The Y-axis LED illuminates; the Function display shows the value for
the Y-axis.
5. Press the +/- Function buttons to set the coordinates of the 1st stitch
for the Y-axis.
6. Press the +/- Program buttons to select the next stitch.
7. Repeat steps 3 to 5 for all additional stitches.
8. Press the Ready button to save the edited sewing pattern.
9. Press the Reset button.
 The LED in the button switches off.
10.Press the USB button.
 The LED in the button switches off.
11.23Error messages
If an error occurs, the Error LED illuminates.
Error Description Possible cause Remedy
E 8 Error table data Unable to read the table
data
Save the table data
again.
E 1 0 Error sewing
pattern number
The selected sewing
pattern is not saved in
ROM or is set to non-
readable. The sewing
pattern is "0"
Press the Reset button to
confirm the sewing
pattern number.