Service manual

Settings via software
Service manual 512/532 Version 00.0 - 12/2013 35
11.4 Selecting a sewing pattern
Prerequisite:
• The machine is in the programming mode, the LED in the Ready button
is off.
1. Press the +/- Function buttons until the desired sewing pattern number
appears in the Function display.
11.5 Scaling axes
Important
Changes to the axes are only valid temporarily. For permanent changes
and the ability to move the sewing pattern, see  11.14 Storing sewing
patterns, page 40.
11.5.1 Scaling the X-axis
1. Press the Selection button until the X-axis LED illuminates.
2. Press the +/- Function buttons until the value for the X-axis is reached.
100 % corresponds to the specified dimensions for the selected sewing
pattern.
11.5.2 Scaling the Y-axis
1. Press the Selection button until the Y-axis LED illuminates.
2. Press the +/- Function buttons until the value for the Y-axis is reached.
100 % corresponds to the specified dimensions for the selected sewing
pattern.
ATTENTION
Damage to the needle if the sewing pattern size does not match
the clamping foot.
Check the clamping foot, adjust if necessary.