Service manual

Adjusting the height of the fabric clamp lift
Service manual 512/532 Version 00.0 - 12/2013 27
7 Adjusting the height of the fabric clamp lift
The following maximum heights apply when adjusting the fabric clamp lift:
• Max. height for class 512: 17 mm
• Max. height for class 532: 13 mm
Cover
Remove the arm cover ( Section 3.3.3, page 11).
Figure 21: Adjusting the height of the fabric clamp lift
Adjusting steps
1. Loosen the screw (1).
2. Adjust the height by turning the fabric clamp lift on the shaft. When doing
this observe the values for the maximum height.
3. Tighten the screw (1).
Order
After changing the height of the fabric clamp lift always check the setting
of the thread wiper as well.
WARNING
Risk of injury!
Crushing hazard and puncturing injuries due to
moving and sharp parts.
Switch off the sewing machine before adjusting the
fabric clamp lift.
①
(1) - Screw