Service manual

Work principles
Service manual 512/532 Version 00.0 - 12/2013 17
5. Close the hook flap ( Section 3.3.7, page 14).
6. Fit the work surface (4).
7. Tighten the screw (3) for the work surface (4) firmly in place.
8. Mount both springs of the fabric clamp (1).
3.4 Surfaces on shafts
Screw onto the
surface
Figure 12: Surfaces on shafts
Some shafts have flat surfaces at those points where the components are
screwed on. This strengthens the connection and setting work is made
easier.
Always make sure that the whole screw is seated completely on the
surface.
2
1
(1) - Surface (2) - Shaft