Operating instructions

Create seam pattern
In this menu, the X- and Y-coordinates are entered for each individual
stitch.
Note
In order to enter stitch operations (e.g. intermediate cutting), first
complete the seam pattern (entering of the coordinates) and then
insert the stitch operation through editing in the menu “Changing seam
pattern”.
X1:
Input of the X-coordinate for stitch 1
Input: -20.0 – +20.0
Y1:
Input of the Y-coordinate for stitch 1
Input: -10.0 +10.0
Note:
The value X1 can be changed according to the description in
Chapter 8.3.1.
After c onfirming the value for X1 with the “OK ” key,usethe“ò“keyto
select the menu item Y1.
The values for Y1, X2, Y2, X3 and Y3 can be altered similarly as
described for the value X1.
After c onfirming the input for Y3 with the “OK” key,usethe“ò”keyto
select the menu item “Add stitch”.
After s election of this line with the “OK” key, the next coordinates Xn+1
and Yn+1 (here: X4 and Y4) are given in the two upper menu lines. The
selection bar changes to the line Xn+1 (here: X4) automatically. The
values Xn+1 and Yn+1 can be altered as described above when
required. This procedure can be repeated until the stitch coordinates
are all entered.
Add stitch
Function for adding a stitch.
The coordinates for the first three stitches (here: X1/Y1, X2/Y2 and
X3/Y3) are shifted upwards and the display shows Xn+1/Yn+1 (here:
X4/Y4).
1
63
X1: 0.0
Y1: 0.0
X2: 0.0
Parameters
Y2: 0.0
X3: 0.0
Y3: 0.0
Append stitch