Operating instructions

7.6 Replacing the shuttle bobbin

Caution – Risk of Injury !

Turnthemainswitchoff.

Change hook thread bobbin only when automatic bartacker

is switched off.

Taking off the empty bobbin

–

Pull down hook cover 3.

–

Raise up the bobbin enclosure hood 1.

–

Take out the upper part of the bobbin enclosure 2 with the bobbin 6.

–

Remove the empty bobbin from the upper part of the bobbin

enclosure 2.

Inserting a full bobbin

–

Place full bobbin in the top of bobbin case 2.

–

Thread bobbin thread through slot 5 below tension s pring 7 in the

drill-hole 4.

–

Pull out the tension spring from the bobbin enclosure 2 about

2.5 cm.

When the thread is being pulled out, the bobbin must rotate in the

direction shown by the arrow.

–

Replace bobbin housing 2.

–

Close bobbin enclosure hood 3.