Operation Manual

Inserting a full bobbin

–

Place the full bobbin in the bobbin case 2.

Here take care that when thread is being pulled off the bobbin

must turn

counterclockwise

(see the arrow direction)!

–

Swing in the bobbin case 2.

–

Pull the thread through the slot 1 into the opening 3 on the spring 4.

ATTENTION !

A thread sliding out of slot 1 can lead to missing stitches

and needle breakage.

Therefore pull the thread so far through slot 1 until it lies secure in the

opening 3 on the spring 4.

–

Pull the thread approx. 5 cm out of the bobbin case.

–

Close the cover.

–

Start a new sewing sequence.

1 2 3 4