Operation Manual

Sewing sequence Operation / Remarks
At the seam middle
Interrupting the sewing sequen-
ce
Sewing the corner
Continuing the sewing sequen-
ce (after release of the pedal)
Sewing the intermediate bar-
tack
- Release the pedal (rest position) .
The machine stops in the 1st position
(needle down).
The sewing feet are down.
- Step the pedal half back.
The machine stops in the 1st position
(needle down).
The sewing feet are raised.
- Turn the material around the needle.
- Step the pedal forward.
The machine sews with the rpm determined via
the pedal.
The beginning bartack is
not
sewn.
- Press key 1 and hold the pedal .
The machine sews in reverse as long as key X
is pressed.
The rpm is determined via the pedal.
At the seam end
Removing the material
Not
lifting the sewing feet.
Not
sewing the end bartack
- Step the pedal completely back and hold down.
The end bartack is sewn.
The thread is trimmed.
The machine stops in the 2nd position.
The sewing feet are lifted.
- Briefly step the pedal completely back.
The end bartack is sewn.
The thread is trimmed.
The machine stops in the 2nd position.
The sewing feet are down.
- Press key 2 (bartack suppression).
Step the pedal completely back.
The end bartack is
not
sewn.
The thread is trimmed.
The machine stops in the 2nd position.
The position of the sewing feet is dependent on
the position
of the pedal:
a) Pedal stepped back and held down:
- Sewing feet lifted.
b) Pedal released (rest position):
- Sewing feet down.
31