Operation Manual

12
5.2.2 Changes of setting parameters of stopmotor setting considering original producer setting
Parameter Parameter
No value
111 - Max. revolutions (according to a type of machine)
116 180 Trimming revolutions
170 - Reference position
171 30 First position of needle
192 340 Delay angle of tensioner switch on
202 120 Delay of start run after switch off the signal foot
225 3 Type of the machine
5.3 Setting stopmotor S359 600052 XX-EFKA VD 552/6F82FA and S359 600056 XX-EFKA VD 554/6F82FA
5.3.1 Setting position reader
Positions are set by means of discs with cut outs directly in position reader.
Setting bottom position:
- Disassemble the cover of position reader
- Disconnect head power supply cable from drive
- Switch on the power supply switch
- Step treadle shortly down forwards (machine stops in first position of needle)
- Switch off the power supply switch
- Turn the beginning of cut out 1 of coinciding discs so that machine would stop at the value 135° of the hand wheel
- Carry out check by repeating procedure
Setting upper position of thread lever:
- Step treadle down backwards (machine stops in upper position of needle)
- Switch off the power supply switch
- Turn the beginning of cut out 2 of separate disc so that machine would stop at the value 65° of the hand wheel
- Carry out check by repeating procedure
5.3.2 Changes in parameters of stopmotor setting considering original producer setting
Parameter Parameter
No value
111 Max. revolutions (according to a type of machine)
116 180 Trimming revolutions
136 ON Stitch by thread trimmer (back)
192 86 Delay angle of tensioner switch on
202 120 Delay of start run after switch off the signal foot
6. Examination of sewing
Caution! Risk of injury!
Before threading a thread switch the main switch off and wait until the motor stops.
- Check the sense of turning the hand wheel – according to the arrow situated on it.
- Thread a thread.
- Choose sewing material.
- Switch the desirable function on the control panel of stopmotor. Examination should be carried out with selection of fancy bar.
- First sew slowly then speed up the sewing.
- If the stitch does not meet requirements, follow the first part of instructions manual or service book.
2 A
1 A
1
2