Operation Manual

4.7.2 The actual electrical connection

- Stick the clip (1) on wedge (defat the contact surface!).

- Install the power supply cable (2) so that connector (3) is in

the direction of a head. The other connector (connectors) is

(are) connected into terminal box rack of the stop motor

according to the pictographs that are situated on it.

- Install the cable of control panel (4) and connect it to the

terminal box of stop the motor according to the pictographs.

- Pass the cable of position reader through (5) and connect it

to the terminal box of the stopmotor according to the picto-

graphs.

- Install lighting if available and connect its cable (6)to the

cable of transformer.

- Install the earthing cable (7) one end to the hanger (8) and

second end to the holder of stopmotor.

Circuit layout

3 2

680