Operation Manual

Set-up
Operating manual 275 Version 01.0 - 01/201678
6.13Checking the needle positions
The needle positions were correctly set before delivery. Despite
this, the needle positions should be checked before starting the
machine.
Requirements
The following requirements must be satisfied for performing the
test:
• Sewing foot locked in place in the upper position. ( page 42)
• During an intermediate stop the machine stops in position 1
(needle down) ( page 52).
Checking needle position 1
1. Switch on the main switch
2. Briefly press the pedal forwards and then back to the home
position.
3. Check the needle position
Correct setting
The needle is in position 1 (handwheel position "F")
Checking needle position 2
1. Switch on the main switch
2. Press the pedal forwards and then all the way backwards.
3. Check the needle position
Correct setting
The needle is in position 2 (handwheel position "C")
If any of the needle positions are not correct then the needle
positions must be corrected.
Read the controller  Operating manual for more information.