Operation Manual

Set-up
Operating manual 275 Version 01.0 - 01/201674
6.10.2 Machines with DAC mini
On machines with DAC mini the setpoint device is installed at a
different position.
Important: With this subclass a large number of assemblies are
fitted under the table plate. For this reason it is essential to observe
the dimensional diagram of the table plate ( page 67).
Figure 44: Install the setpoint device (with DAC mini)
1. Screw the angle bracket (1) under the table plate at the position
shown in the diagram.
2. Screw the setpoint device onto the angle piece (1).
3. Install the pedal in the same manner as with a machine without
a DAC mini ( page 73).
(1) - Angle piece
①