Operation Manual

Set-up
Operating manual 275 Version 01.0 - 01/201672
6.9 Fitting the controller
The machine is operated using the DAC basic or DAC classic
controller with the OP 1000 control panel.
Figure 42: Fitting the controller
1. Screw the controller (3) onto the four screw holders (2) under
the table plate.
2. Clamp the power cable for the controller into the strain relief
mechanism (1).
3. Screw the strain relief (1) under the table plate.
(1) - Strain relief mechanism (2) - Screw holder
(3) - Controller
①
②
③