Operation Manual

Set-up
Operating manual 275 Version 01.0 - 01/2016 71
6.8 Inserting the machine upper section
Figure 41: Inserting the machine upper section
Important: Remove the supporting screws (4) at the front and in
the middle before fitting the machine upper section!
1. Remove the supporting screws (4) at the front and in the
middle.
2. Fit the machine upper section (1) from above at an angle of 45°.
3. Insert the upper hinge parts (2) into the rubber inlays (3).
4. Fold the machine upper section (1) down and insert it in the
recess.
(1) - Machine upper section
(2) - Upper hinge parts
(3) - Rubber inlays
(4) - Supporting screws
①
②
④
③
Risk of crushing
The machine upper section is heavy.
Take care not to jam your hands when fitting the
machine upper section.
This especially applies when fitting the upper hinge
parts into the rubber inlays.
WARNING