Operation Manual

Set-up
Operating manual 275 Version 01.0 - 01/2016 67
6.5 Fastening the table plate to the frame
Machines without a DAC mini multiple width controller
1. Fasten the table plate to the frame with wood screws (B8 x 35)
according to the dimensions on the diagram.
Figure 36: Dimensions for fastening the table plate to the frame
6.6 Table plate installation with DAC mini
For machines with a DAC mini multiple width controller and edge
cutter, in addition to the normal steps for completing the table
plate ( page 66), the DAC mini (2), distribution box (3), sewing
lamp transformer (1) and knee switch (4) must also be installed.
Figure 37: Fasten the DAC mini to the table plate
(1) - Sewing lamp transformer
(2) - DAC mini
(3) - Distribution box
(4) - Knee switch
①
②
③
④