Operation Manual

Set-up
Operating manual 275 Version 01.0 - 01/201666
6.4 Completing the table plate
Figure 34: Completing the table plate
1. Insert the upper section support (1) into the holes in the table
plate.
2. Fit the rubber inserts (2) into the recesses.
3. Insert the rest plugs (3) and slide on with compression springs.
4. Screw the drawer (4) and its brackets under the table plate at
the left.
5. Screw the cable duct (5) under the table plate at the rear.
6. Center punch the screw positions of the oil pan (6) and screw
the oil pan into position under the table plate cutout using wood
screws.
In addition, for machines with an edge cutter:
Waste chute for
edge cutter
Figure 35: Install the waste chute for edge cutter
7. Center punch the screw positions of the waste chute (7) and
screw the waste chute into position under the table plate cutout.
8. Connect the oil pan (6) and waste chute (7) with screws.
(1) - Upper section support
(2) - Rubber inlays
(3) - Rest plugs
(4) - Drawer
(5) - Cable duct
(6) - Oil pan
①
④
②
⑤
③
⑥
⑥
⑦
(6) - Oil pan (7) - Waste chute