Operation Manual

Operation
Operating manual 275 Version 01.0 - 01/201648
5.17.3 Changing between smooth sewing and a single
multiple width
1. Press the = key for smooth sewing and the key for the desired
multiple width sequence at the same time.
 The green LEDs above both keys light up.
2. Changing between smooth sewing and multiple width:
Actuate the knee switch (or at the end of the seam, press the
foot pedal all the way back to cut the thread).
3. Switching off the alternating processing mode:
Press the =key for smooth sewing.
5.17.4 Sewing with up to 8 different multiple widths
1. Deactivate all sequence keys that are not required:
To do this, press the corresponding sequence key and the
(De-) Activation key ( page 46) at the same time.
 The red LEDs above the deactivated keys light up.
2. Activate all keys for the desired sequences:
To do this, press the desired sequence key and the
(De-) Activation key ( page 46) at the same time.
 The red LEDs go out. The keys are activated.
 The first activated sequence is started when sewing starts.
 The green LED above the currently sewn sequence lights up
and the display shows the current upper transport value.
3. Changing to the next sequence:
Actuate the knee switch (or at the end of the seam, press the
foot pedal all the way back to cut the thread).
 The machine automatically switches to the first multiple width
sequence after the last multiple width sequence
If the desired multiple width cannot be achieved in a sequence
then the upper transport length can be changed using the Plus/
Minus keys. The change is saved as soon as the next sequence
is switched to.