Operation Manual

Operation
Operating manual 275 Version 01.0 - 01/2016 45
5.17Multiple width control using the DAC mini
The DAC mini allows programming and semi-automatic calling of
different multiple widths within a seam. You can save up to 30
different programs, each with up to 8 different multiple width
sequences. The current multiple width is shown in the display in
every sequence and can be manually changed at any time.
Switching from one sequence to the next is performed using the
knee switch or automatically when the thread is cut at the end of
a seam.
Figure 26: DAC mini control panel
Key Function
Key for smooth sewing
The Plus/Minus keys should be used to assign an
upper transport value to this key, which is to be used
for sewing material without crimping.
The green LED above the key lights up when the
function is switched on.
Sequence keys 1 to 8
Each of the sequence keys can be assigned its own
upper transport value via the Plus/Minus keys.
The LEDs above the keys indicate the following states:
• Red LED on = sequence is active
• Both LEDs off = sequence is activated but not
currently being executed
• Green LED on = Sewing sequence currently being
executed
①
(1) - Key for smooth sewing
(2) - Sequence keys
(3) - Display
(4) - Plus/Minus keys
(5) - (De-) Activation key
(6) - F key (Enable/Function)
(7) - Direction change key 0
②④⑤③⑥⑦
...