Operation Manual

Operation
Operating manual 275 Version 01.0 - 01/201644
5.16.2 Setting the edge cutter with a DAC mini
On machines with a DAC mini the switch (2) for the edge cutter
is located on the rear side of the DAC mini under the table plate.
Figure 25: Setting the edge cutter with a DAC mini
Setting the edge cutter with a DAC mini
1. Set the switch (2) to the desired position:
• Switch off the edge cutter: Position 0
The LED (1) is off.
• Low speed: Position I
(for small to medium stitch lengths)
• High speed: Position II
(for medium to large stitch lengths)
 After moving the switch (2) to position I or II the LED 1)
flashes. At the start of sewing the edge cutter switches on
automatically after the 1st stitch. The LED (1) lights up
constantly while the edge cutter is working.
5.16.3 Enabling the edge cutter with a DAC mini
The edge cutter must be enabled via the DAC mini ( Section
5.17 Multiple width control using the DAC mini, page 45) for every
sequence in which it is to work.
Enabling the edge cutter with a DAC mini
1. Press the F key on the DAC mini control panel.
The green LED above the F key lights up.
The edge cutter is enabled.
①
(1) - Edge cutter LED (2) - Edge cutter switch
②